Hughes DW6000 User Manual
Appendix B • Installing the indoor equipment using dial-up commissioning
1033295-0001 Revision 2
93
Connect to customer
computer and confirm
surfing
1. Unplug the DW6000 from the wall outlet or other power
source.
2. Wait 10 seconds and then plug the power cord into the wall
outlet or surge protector.
3. Make sure that the LEDs function properly. Make sure the
transmit and receive cables are clearly labeled at the
connectors.
connectors.
4. The DW6000 is now commissioned. Connect the customer’s
computer and the DW6000 with Ethernet cable. See
Figure 84. If the computer has a functioning and properly
configured Ethernet interface, it will surf the Internet. If the
customer cannot surf, see the instructions below.
Figure 84. If the computer has a functioning and properly
configured Ethernet interface, it will surf the Internet. If the
customer cannot surf, see the instructions below.
Refer to Final installation check requirements on page 29 to
make sure you fulfill all final installation requirements.
make sure you fulfill all final installation requirements.
Figure 83: ACP passes; select Exit