Hughes DW6000 User Manual

Page of 174
Appendix C • Installing the DW6000 using Installer Console
96
1033295-0001 Revision 2
Installation PC requirements
The installer laptop PC must fulfill the following requirements. 
You will receive network parameters during installation.
• Ethernet enabled network interface card (NIC)
• Windows 98 SE, Windows Me, Windows 2000, or Windows 
XP with TCP/IP configured to automatically obtain IP 
addresses. Appendix D – Configuring the installer laptop for 
IP addressing,
 on page 121.
Customer installation
requirements
The customer must have or provide:
• Operating system
– PC: Windows 98 SE, Windows Me, Windows 2000, 
Windows XP
– MAC: 9.0 - 10.2 (excludes 10.0)
• Processor
– PC: Pentium II 333 Mhz or faster
– MAC: 300 Mhz or faster
• Memory
– PC: 64MB RAM, Windows 98SE and Me; 128MB RAM 
Windows 2000 and XP.
– MAC: 128MB
• Free hard drive space
– PC: 100MB
– MAC: 150MB
• A functioning 10/100 Ethernet interface installed on at least 
one computer. This is not necessary to commission the 
DW6000, but you must ensure the customer can surf before 
you leave.
• A 6-foot Cat-5 Ethernet cable is supplied to connect the 
DW6000 and the customer’s computer. If a longer cable is 
needed the customer must supply it. Either crossover or 
straight-through Cat-5 Ethernet cable can be used.
• A power strip or surge protector. If one of these is not present, 
proceed with the installation using the wall outlet or other 
power source.
• An analog phone line.
Note:
If the customer wants to connect a network to the 
DW6000, he or she must do so via an Ethernet hub or other such 
equipment. The customer must supply and configure the hub and 
cables. IP address information is provided during commissioning.