Hughes DW6000 User Manual
Appendix F • Installation checklist
1033295-0001 Revision 2
137
Appendix F
Installation checklist
Installation summary
and checklist
and checklist
The following DW6000 components are installed:
• Antennas (outdoor unit or ODU)
• Coaxial cable (IFL)
• DW6000
• Coaxial cable (IFL)
• DW6000
The main tasks required to install an DW6000 are summarized
below. For dialup commissioning, the customer should have an
analog phone line and a functioning Ethernet interface.
below. For dialup commissioning, the customer should have an
analog phone line and a functioning Ethernet interface.
Assemble and install the satellite antenna. Run cables from the outdoor components
to the indoor equipment. Clearly label the receive and transmit coaxial cable at the
antenna, ground block, and indoor unit connectors.
to the indoor equipment. Clearly label the receive and transmit coaxial cable at the
antenna, ground block, and indoor unit connectors.
Connect the DW6000 to the installer PC Ethernet port and power up the
DW6000. Use surge protectors.
DW6000. Use surge protectors.
Perform antenna pointing and automatic cross pol.
Start commissioning the unit, using either SBC or Websetup if SBC is not
available. Register the customer and select subscription options.
available. Register the customer and select subscription options.
Transfer of parameter information to DW6000. Exit Websetup.
Reboot the DW6000 to finish registration.
Disconnect installer laptop PC and connect the DW6000 to the customer’s
computer.
computer.
Verify customer operation, information recorded on Quick Start Guide cover,
icon placed on customer PC desktop, customer surfed to myDIRECWAY.COM
and downloaded DW6000 User Guide, and receive and transmit cable labeling.
Optional: assist in customer computer configuration.
icon placed on customer PC desktop, customer surfed to myDIRECWAY.COM
and downloaded DW6000 User Guide, and receive and transmit cable labeling.
Optional: assist in customer computer configuration.