Hughes DW6000 User Manual

4. Assemble indoor equipment. Assemble DW6000 and connect 

to laptop. Power up DW6000 and laptop and verify 
connectivity.

5. Compute pointing coordinates using the SBC interface 

installation software.

6. Assemble the antenna. Pre-set elevation and polarization 

values.

7. Mount the satellite antenna. 
8. Run cables and ground the system. Clearly label the receive 

and transmit coaxial cables at the antenna, ground block, and 
indoor unit connectors.

9. Receive point the antenna using the SBC interface.

10. Auto cross pol the antenna. When the antenna is locked in 

place and continues to pass isolation, finish weather sealing 
the coaxial cable connections.

11. Register the DW6000 using SBC. Customer supplies SAN 

12. Verify DW6000 has finished downloading and connect 

customer’s PC. Customer should use power strip or surge 
protector. Customer checks that TCP/IP settings are set to 
obtain an IP address automatically and restarts the computer.

13. Customer verifies connectivity by surfing to a Web site.
14. Record site ID and assigned IP address(es) for the customer 

on the Quick Start Guide. Clean up trash and verify 
connections are weather proofed. Optional: assist in customer 
computer configuration.

15. Complete FSO within 24 hours.

Before leaving confirm the following items:

•

 in the User Interface must show 

“All files are up-to-date."

• The installer has surfed using the user's computer to at least 

the myDIRECWAY site or another Internet site after the 

 shows "All files are up-to-date."

• The customer’s 

 page printed out and 

the site ID, Gateway ID, and subnet mask recorded on the 
Quick Start Guide.

• Help the customer create a browser shortcut to the System 

Control Center. If necessary rename the shortcut "System 
Control Center."

• Help the customer download the DW6000 User Guide from 

myDIRECWAY.com.