Hitachi Microscope & Magnifier S-3400N User Manual
2.3.6
2 - 27
2.3.6.3 Scan Control Windows
Fig. 2.3-8 Scan Control Block
(1) Run button
Used to run or freeze scanning. The button is at
when scanning and changes to
while scan is frozen.
To stop scanning, click the button. Scanning continues until it reaches the end of the frame
and then stops. During this time, the display in the upper left section of the image shows
"Going to Freeze", and after the image stops, the displays shows "Freeze".
In the slow scan mode, to stop the scanning process before the last frame is reached during
the "Going to Freeze" process, click this button again.
To stop scanning, click the button. Scanning continues until it reaches the end of the frame
and then stops. During this time, the display in the upper left section of the image shows
"Going to Freeze", and after the image stops, the displays shows "Freeze".
In the slow scan mode, to stop the scanning process before the last frame is reached during
the "Going to Freeze" process, click this button again.
(2) Scan speed buttons (TV1 to Red1 in above picture)
14 scanning speeds are assigned to 4 buttons. Each of buttons sets 2 scanning speeds
alternately. To assign scanning speed to each button, click the
alternately. To assign scanning speed to each button, click the
button. The following
dialog will be shown.
Fig. 2.3-9 Scanning Speed Assignment Window