Epson V7 User Manual

M

If an error occurs during data transfer, the 
message window shown on the right is displayed. 

The kinds and the contents of the messages are shown below.  The same messages are 
used for the memory card and CF card.  When using the CF card, the “memory card” in the 
explanation should read as the “CF card.”

OK

Data discrepant

Messages

Contents

Work normally finished.

The specified operation has been concluded normally.

CREC not connecting

CREC is not connecting when selecting a modular jack.

CREC Communication Error

A communication error occurred between V7 and CREC when selecting a 
modular jack.

Memory-Card not setting

A memory card is not inserted.

Memory-Card Capacity over

Cannot write the data into a memory card because the data size in V7 is 
larger than the capacity of a memory card.

Write Protect: ON

Cannot write data into a memory card because the write protect switch in 
a memory card is ON.

Writing Error occurred.

The error occurred while writing data into a memory card.

Selected data does not exist.

The data in the reading target does not exist.

V7 type is different.

The specified type of the data in V7 is different from the type of the 
memory card data.

Selected data can not be read.

The data in a memory card cannot be read.

Reading Error occurred.

The error occurred during writing data into a flash ROM of V7.

Data discrepant

There is some discrepancy in data, when comparing data between a 
memory card and V7.

Screen data on V7 will be broken.

Warning about data destruction in V7 that may occur when transferring the 
font data larger than the present data from a memory card to V7.  (The 
[OK] switch continues transferring; the [Cancel] switch stops transferring.)

Undefined Error occurred.

The error occurred due to some cause other than mentioned above.