Epson V7 User Manual

The “Ethernet” screen is displayed by pressing the [IP Address (English)] switch on the 
initial screen when transferring screen data via Ethernet for the first time, or by pressing the 
[Ethernet] switch on the Main Menu screen when transferring screen data to the V7 series.  
This screen is used for setting the IP address (a number that identifies the V7 series on the 
network) that is indispensable for Ethernet communications.

Depending on whether the LAN (10BASE-T) connector at V7i or the communication 
interface unit CU-03 for V7 is used, the “Ethernet” screen contents and the required 
settings vary as described below.

*1 Network Table

Register IP addresses and other information for the V series, PLCs or computers that should be 
included for Ethernet communications on the V-SFT editor.  ([System Setting]

 

→

 

[Network Table 

Setting]

 

→

 

[Ethernet]

 

→

 

Edit Network Table)  The registered network table can be used or not 

used depending on the [Not Use Network Table/Use Network Table] switch.

Return

<-

Ethernet

Not Use Network Table

It is not used when the gate way or the sub-mask is zero.

IP Address:

Gate Way:

Sub-mask:

Port No.

Connect

->

Setting

Finished

0

0

0

0

0

0

0

0

10000

0

0

0

0

Cursor switches

[Increment/Decrement] switch for the value 
in the cursor position

Determines the setting such as IP address, 
and moves back to the Main Menu screen.

Used for checking the 10BASE-T interface.

Normal: Connect
Error:

Disconnect

Moves back to the Main Menu screen or 
the initial screen.

Selects [Not Use Network Table] or [Use Network Table].

*1

Network table 
number