Enlight EN-7230 User Manual

Fig:14

Fig:13

Fig:12

Reinstall top cover making sure to line up 

tabs on back (Fig.12).  Then install side 

panels by placing on rail guides (Fig.13), 

and sliding towards back of chassis.  Use 

hex screws to fasten side panels in place.

To replace top cover, spread sides as 

shown in (Fig. 14).  Slide vertically down 

and make sure slide fasteners guides are 

properly set in the rails.  Once top cover is 

set properly on the rails, slide away from 

you to close the top cover.  Use hex head 

screws to fasten top cover to chassis.

Fig:9

Fig:11

Fig:10

A. Identify if M/B is AT, ATX or microATX.

B. Place chassis on its side with electronic      

     Bay in view (Fig. 9)

C. Using your choice of standoffs or stakes     

     to fasten M/B, prepare and screw into 

     mounting plate. 

D. Make sure punch out holes for I/O ports 

     on the I/O plate are punched out matching 

     ports on the M/B.

E. Install at an angle, first by lining up the I/O 

     ports on the M/B with I/O plate. (Fig. 10)

F. Once holes are lined up, set M/B on 

    standoffs or stakes and make sure the 

    M/B is seated properly. (M/B mounting 

    screw holes vary with manufacturer.  

    Please refer  to M/B user manual for 

    details.)

G. Fasten M/B using hex head screws.

H. Connect wiring as directed in M/B user 

     Manual. 

Slide into P/S area and fasten with hex head 

screws (Fig. 11).