Elsa Cable User Manual
Configuration modes
ELSA MicroLink Cable
21
English
What's happening on the line?
Trace Outputs
Trace outputs may be used to monitor the internal processes in the cable modem during
or after configuration.
or after configuration.
The trace outputs are slightly delayed behind the actual event, but are always in the
correct sequence. This will not usually hamper interpretation of the displays but should
be taken into consideration if making precise analyses.
correct sequence. This will not usually hamper interpretation of the displays but should
be taken into consideration if making precise analyses.
How to start a trace
The command to call up a trace follows this syntax:
trace [code] [parameters]
The trace command, the code, the parameters and the combination commands are all
separated from each other by spaces. And what is lurking behind the code and
parameters?
separated from each other by spaces. And what is lurking behind the code and
parameters?
This code ...
... in combination with the trace causes the following:
?
Displays a help text
+
Switches on a trace output
-
Switches off a trace output
#
Switches between different trace outputs (toggle)
no code
Displays the current status of the trace
This parameter ...
... brings up the following display for the trace:
Status
Status messages for the connection
Error
Error messages for the connection
IP router
IP routing
IP-RIP
IP Routing Information Protocol
ICMP
Internet Control Message Protocol
ARP
Address Resolution Protocol
Masquerade
Processes in the masquerading module
DHCP
Dynamic Host Configuration Protocol
This combination
command
command
... brings up the following display for the trace:
All
All trace outputs
Display
Status and error outputs