Furuno Satellite Compass SC-50 User Manual
2. INSTALLATION
2-19
2.6 Initial
Settings
Follow the procedures in this section to enter initial settings.
NOTICE
Improper menu settings may stop output of
data and display the message "RATE
ERROR." Be sure to enter correct data.
data and display the message "RATE
ERROR." Be sure to enter correct data.
2.6.1
Confirming satellite status; choosing mounting method
1. Turn on the processor unit and then press the [MENU] key to show the menu.
MAIN MENU
SATELLITE
WAAS/DGPS
I/O SETUP
INST MENU
ERASE
TRIP MENU
WAAS/DGPS
I/O SETUP
INST MENU
ERASE
TRIP MENU
ALARMS
MESSAGES
GPS SETUP
SYS SETUP
SOFT VER.
OTHERS
GPS SETUP
SYS SETUP
SOFT VER.
OTHERS
Main menu
2. Use the Omnipad (
) to choose “INST MENU” and then press the [ENT]
key.
INSTALLATION SETUP
MOUNTING
:
WALL
DIRECTION :
A
LANGUAGE
: ENG
ROLL OFFSET : 0.0
PITCH OFFSET : 0.0
PITCH OFFSET : 0.0
Installation setup menu
3. Confirm that “MOUNTING” is selected and then press the [ENT] key.
4. Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or
4. Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or
“INVERT” as appropriate.
5. Press the [ENT] key.
6. Choose “DIRECTION” and then press the [ENT] key.
7. Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as
6. Choose “DIRECTION” and then press the [ENT] key.
7. Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as
appropriate. Refer to section 2.3.1.
8. Press the [ENT] key.
9. Press the [SAT STATUS] key.
9. Press the [SAT STATUS] key.