Clarion CZ702 Car CD/MP3 Player CZ702 User Manual

English

19

CZ702

1.  This set is exclusively for use in cars with a 

negative ground 12 V power supply.

2. Read these instructions carefully.

3.  Be sure to disconnct the battery “terminal” before 

starting. This is to prevent short circuits during 

installation. (Figure 1)

1.  Do not open the case. There are no 

user serviceable parts inside. If you 

drop anything into the unit during 

   installation, consult your dealer or an 

authorized 

 service center.

2.  Use a soft, dry cloth to clean the case.  

Never use a rough cloth, thinner, 

benzine, or alcohol etc. For tough dirt,  

apply a little cold or warm water to a 

soft cloth and wipe off the dirt gently.

1) Before Starting

 .................................................................................

19

2) Package Contents

 ............................................................................

19

3) General Cautions

 .............................................................................

19

4) Cautions on Installation

 ....................................................................

19

5) Installing the Source Unit

 .................................................................

19

6) Removing the Source Unit

 ............................................................... 22

7) Wiring and Connections

 ...................................................................

21

8) Connecting the accessories

 ............................................................. 22

Car battery

Source unit

 ..................................................

1

Front panel

 ..................................................

1

Trim ring

 ......................................................

1

Mounting bracket

 .........................................

1

Screws M5x6 mm

 ........................................ 4

L-key

 ............................................................ 2

Wire connector

 ............................................

1

Remote control unit (with battery)

................

1

DCP case

 ....................................................

1

Owner’s manual

...........................................

1

Special screw (Front panel lock)

 .................

1

Warranty card

 ..............................................

1

1.  Prepare all articles necessary for 

installing the source unit before 

starting.

2. Install the unit within 30° of the

  horizontal plane. (Figure 2)

3.  If you have to do any work on the car 

body, such as drilling holes, consult 

your car dealer beforehand.

4.  Use the enclosed screws for 

installation. 

   Using other screws can cause 

damage. 

  (Figure 3)

1.  Place the mounting bracket into the instrument panel, use a screwdriver to bend 

each stopper of the mounting bracket inward, then secure the stopper.

2. Wire as shown in Section 7) .

3. Insert the source unit into the mounting bracket until it locks.

4.  Take care of the top and bottom of the trim ring and mount it so that all the hooks 

are locked.

1. Some car models require special mounting kits for proper installation. 

  Consult your 

 dealer for details.

2. Fasten the front stopper securely to prevent the source unit from coming loose.

(182 mm)

53 mm

Hole

Max 30˚

Chassis

Chassis

Damage

Max. 6 mm (M5 screw)