Avaya Media Gateway G700 User Manual

This procedure assigns network region 1, as an example, to the S8300 media server. 

1. At the SAT prompt, type change ip-interfaces procr.

The S8300 displays the IP Interfaces screen for the media server. 

2. The field Enable Ethernet Port? should indicate y (yes). The Node Name should be the IP 

address of the S8300 media server. 

3. In the Allow H.323 Endpoints field, enter a ’y’ to allow H.323 endpoint connectivity to the 

server.

4. In the Allow H.248 Endpoints field, enter a ’y’ to allow H.248 media gateway connectivity 

to the server.

5. In the Gatekeeper Priority field, enter a value is used on the alternate gatekeeper list. The 

lower the number the higher the priority. Valid values for this field are one through nine with 
five being the default. This field displays only if the allow H.323 endpoints field is set to y. 

If the primary controller has LSPs, you must enter the LSP node names on the Survivable 
Processor form to enable the LSPs to get translations updates from the primary controller. Once 
the LSPs are successfully entered on the LSP screen, their status can be viewed with the list 
survivable-processor

 command.

Note:

The LSP node names must be administered on the node-names-ip form before 
they can be entered on the Survivable Processor screen.

change ip-interfaces procr                                    Page   1 of 1

 

                                   IP INTERFACES

Type: PROCR

Node Name: procr

IP Address: 135.9.41.146

Subnet Mask: 255.255.255.0

Enable Ethernet Port? y 

Allow H.323 Endpoints? y

Nework Region: 1

Allow H.248 Gateways? y

  

Gatekeeper 

Priority: 

5