Avaya Media Gateway G700 User Manual

1. At the SAT command line, type add survivable-processor <name>, where <name> 

is the LSP name from the Node Names screen. 

The Survivable Processor screen appears.

2. The type field is automatically populated with LSP. LSP appears in the field if the node 

name is not associated with ESS. 

3. Enter a network region for the LSP. The default is 1. However, there may be a different 

network region better suited for the LSP to provide media gateway and IP phone support. 

Skip to 

on page 221 to continue. 

Complete the procedures in this section if the primary controller for the G700 you are installing 
is an S8400, S8500, or S8700-series Media Server. If the primary controller is an S8300, you 
should have completed the procedures in 

This document covers only the administration of Communication Manager required for the 
G700 media gateway to communicate with the primary controller over a customer’s network. 
For the majority of required administration, see Administrator Guide to Avaya Communication 
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication 
Manager, 555-233-504.

In this section, you will use the SAT interface on the primary controller to:

●

●

●

●

●

add survivable-processor sv-mg2-lsp

Page   1 of  xx 

 

SURVIVABLE PROCESSOR - PROCESSOR ETHERNET

 

Node Name: sv-mg2-lsp

IP Address: 128.256.173.101

Type: LSP

Network Region: 1