ADIC SNC 5100 User Manual

The events that have been logged in the SNC 5100’s Event Log can be 
displayed on the service terminal or viewed from the ADIC Management 
Console. 

For more information, see the ADIC Management Console User Guide.

This information may be useful because you can see the normal events and any 
abnormal events that may lead you to the source of an internal or external 
failure.

Each entry contains a sequence number, day, and time-stamp, the event code, 
event source (interface name or system process), an index, and a description of 
the event.

If the Real Time Clock has been set, the time-stamp will be real time. 
Otherwise, the time stamp will be relative to the boot-time.

The Event Log holds more than 2000 events. When the log becomes full, the 
oldest events are overwritten by the most recent events.

You can choose to view only those events logged since the SNC 5100 was last 
booted or you can view a longer list of events that have accumulated from 
previous boots.

You can choose to view events by severity level. Selecting Warning will 
display Warning and Notice events. Selecting Information will display 
Information, Warning and Notice events. 

See the 

 or the 

See also Figure 6 on page 35, “Detail of Event Log Listing From Service Port.”

If an event code 43 was reported to the ADIC Management Console client, it is 
an indication that the SNC 5100 performed an error recovery operation and had 
to reset the Fibre Channel interface to clear a lock-up condition. 

For more information, see the ADIC Management Console User Guide.