Digicom COMSPHERE 3911 User Manual
COMSPHERE 3900 Series Modems
14-12
September 1998
3910-A2-GN32-40
Table 14-2
(8 of 10)
391x Series AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
&Vn
View Configuration Options. Displays each configuration group within the
Active (Operating), Active (Saved), Customer 1, and Customer 2
configuration areas as well as the telephone numbers stores in directory
locations 1–24.
Active (Operating), Active (Saved), Customer 1, and Customer 2
configuration areas as well as the telephone numbers stores in directory
locations 1–24.
&V0
Active (Operating) configuration options.
&V1
Active (Saved) configuration options.
&V2
Customer 1 configuration options.
&V3
Customer 2 configuration options.
&V4
Directory locations 1–24.
None
&Wn
Write (Save to Memory). Saves the current configuration options in
Active (Operating) to one of three configuration areas:
Active (Operating) to one of three configuration areas:
&W0
Saved to Active(Save).
&W1
Saved to Customer 1.
&W2
Saved to Customer 2.
Configure\Save
&Xn
Transmit Clock Source.
&X0
Internal. Modem provides transmit clock source for
synchronous data (Pin 15).
synchronous data (Pin 15).
&X1
External. Modem derives external transmit clock source
provided on Pin 24 for synchronous data.
provided on Pin 24 for synchronous data.
&X2
Receive Clock Loop. Modem derives transmit clock source
from receive signal for synchronous data (Pin 17).
from receive signal for synchronous data (Pin 17).
Configure\Edit\
DTE Interface
DTE Interface
&Zn=x
Store Telephone Numbers. Modem saves the telephone numbers and
dial command modifiers (if any) entered for x (up to 40 characters in
length) in Directory Location n (1–24). For example, the command
AT&Z1 = 5551234 stores the telephone number 555-1234 into directory
location 1.
dial command modifiers (if any) entered for x (up to 40 characters in
length) in Directory Location n (1–24). For example, the command
AT&Z1 = 5551234 stores the telephone number 555-1234 into directory
location 1.
To clear a telephone number from a memory location, issue the &Zn=x
command without entering a telephone number.
command without entering a telephone number.
Call Setup\
Change
Directory
Change
Directory
\An
Maximum Frame Size.
\A0
64 bytes.
\A1
128 bytes.
\A2
192 bytes.
\A3
256 bytes.
\A4
32 bytes.
\A5
16 bytes.
Configure\Edit\
V42/MNP/Buffer
V42/MNP/Buffer
\Cn
Error Control Negotiate Buffer.
\C0
Disable.
\C1
Enable.
\C2
Disables and switches modem to Buffer mode.
Configure\Edit\
V42/MNP/Buffer
V42/MNP/Buffer