DeLonghi Pinguino Air-to-Air PAC C100E Instruction Manual

6

•  If the windows are large, use the window bracket extension

(16) (if provided) to cover your window aperture, extending 
it to the required length, then blocking it with the locking 
pins supplied (see figure E). Make sure you do not cover the 
hole  for the window outlet.

If required, your appliance can also be installed semi-
permanently (Fig. F).

Proceed as follows:
•  Drill a hole ø 5,25 inches (134 mm) in an outside wall or

through a window pane.  

 

Respect the  dimensions and height  of the hole given in 
figure G and  H.

 

•  Fit the wall flange (10) into the hole.
•  Fit  the  air  exhaust  hose    (11)    in  the  relevant  housing

located on the rear side of the appliance. (fig. A).

•  Fit the end of the hose (11) to the wall flange (10) as shown

in fig. H.

When the hose (11) is not connected, the drilled  hole can be 
closed with the flange cap (10).

NOTE: When installing the air conditioner semi-permanently, 
you should leave a door slightly open  little as   1/2“ (1 cm)  to 
guarantee correct ventilation and room pressure.

NOTE: Keep the air hoses as short and free of curves as possible 
to avoid constrictions.

For help with installation, operation, and for all accessories and 
spare/replacement parts, please contact our toll free customer 
service call center at: 

1-800-322-3848 [US only]

1-888-335-6644 [Canada only] 

01-800-711-8805 (Mexico only] 
or log onto our website at www.delonghi.com

E

H

F

G

D

in the 

window

panel

in the wooden 

kickboard 

of a French 

window

in the wall: 

you are 

recommended 

to insulate the 
section of wall 

using suitable 

insulation.