Datacard Group RL90 User Manual
Power on
14
RP90 Plus E and RL90 User Guide
Power on the laminator
When the optional RL90 laminator is
installed, turn the laminator power on
before powering on the printer.
installed, turn the laminator power on
before powering on the printer.
1
Press the “
|" symbol on the
laminator power switch.
2
The laminator powers on. The
LCD panel displays
"Initializing" and the green
Ready light blinks.
LCD panel displays
"Initializing" and the green
Ready light blinks.
3
"Preheating" is displayed for
approximately four minutes
while the heat roller warms to
operating temperature.
approximately four minutes
while the heat roller warms to
operating temperature.
4
The LCD panel shows "Ready" and the Ready light is steady green
when the laminator is ready to process cards.
when the laminator is ready to process cards.
LCD sequence on laminator startup
Tips for laminator power
•
When connected to a
printer, laminator
messages will not be
displayed until the
printer is powered on.
printer, laminator
messages will not be
displayed until the
printer is powered on.
•
Wait while the laminator
initializes.
initializes.
•
Follow the guidelines for
your organization about
when to power the
laminator on and off.
your organization about
when to power the
laminator on and off.
•
Check that the red
INLET switch, located
on the back of the
laminator, is set for your
input voltage.
INLET switch, located
on the back of the
laminator, is set for your
input voltage.