Datacard Group RL90 User Manual

Printer error recovery

56                    

RP90 Plus E and RL90 User Guide

Single-sided printing can cause the card to warp depending on the type of 
cards you use. Use the bend remedy Temp Level settings to correct the 
condition and use the Speed settings to fine tune the adjustment.

You can also change the printer setting using the Status Monitor. See 

.

Press the printer MENU 
key until "Bend Remedy" is 
displayed. 

Press the ENTER key. 
Choose from three bend 
remedy settings. Use the 
up and down arrow keys to 
select "Temp Level", 
"Speed", or "Cooling Time".

Temp Level
Use the up and down 
arrow keys to set the 
bend remedy roller 
temperature. There are 
seven settings: off and -
5 to 0. The higher the 
value, the higher the 
temperature. Press the 
ENTER key to confirm 
the value.

Speed

Use the up and down arrow keys to set the bend remedy roller 
speed. There are five settings from -2 to +2; the higher the value, 
the faster the speed. Press the ENTER key to confirm the value.

Cooling Time

Set the cooling time from zero to 15 seconds using the up and 
down arrow keys. Press the ENTER key to confirm the value. 

Press the RESET and then the ENTER key to initialize the printer.

You must initialize the 
printer by pressing the 
RESET and then the 
ENTER key. Settings will 
not be saved if the 
printer is not initialized.

Double-sided printing 
with the Temp Level set 
to a high temperature 
can cause severe 
warping. Set the Temp 
Level to OFF when 
printing on both sides of 
the card.

Allow sufficient time for 
the bend remedy roller to 
cool after decreasing the 
temperature setting.