BMW 2009 X6 xDrive50i Owner's Manual

124

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.
You can operate the device when the engine is 
running or when the ignition is switched on.

If the device cannot be used after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions for the original hand-held transmit-
ter or hold down the programmed memory but-
ton

1 of the integrated universal remote control. 

If the LED

2 on the integrated universal remote 

control flashes rapidly for a short time and then 
remains lit for approx. 2 seconds, this indicates 
that the original hand-held transmitter uses an 
alternating-code system. In the case of an alter-
nating-code system, program the memory but-
tons

1 as described at Alternating-code hand-

held transmitters.

<

To program the integrated universal remote 
control, consult the operating instructions for 
the equipment to be set. You will find informa-
tion there on the possibilities for synchroniza-
tion.
When programming hand-held transmitters 
that employ an alternating code, observe the 
following supplementary instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled device.

2.

Program the integrated universal remote 
control as described above in the section 
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the 
device to be set, e.g. on the drive unit.

4.

Press the button on the receiver of the 
device to be set. After step 4, you have 
approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 

of the integrated universal remote control 
three times.

The corresponding memory button 

1 is now 

programmed with the signal of the original 
hand-held transmitter.

Should you have questions, please con-
tact your BMW Sports Activity Vehicle 

Center.

<

Press the left and right-hand memory button

1 

for approx. 20 seconds until the LED

2 flashes 

quickly:
All stored programs are deleted.

1.

Hold the original hand-held transmitter at 
a distance of approx. 4 in/10 cm to 12 in/
30 cm from the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the relevant sys-

tem of the original hand-held transmitter 
used.

<

2.

Press the desired memory button

1 of the 

integrated universal remote control.

3.

When the LED 

2 flashes slowly after approx. 

20 seconds, press the transmit button of 
the original hand-held transmitter. Release 
both buttons as soon as the LED

2 flashes 

rapidly. If the LED

2 does not flash rapidly 

after approx. 15 seconds, alter the distance 
and repeat the step.

1 Adjustment button
2 Display

Online Edition for Part no. 01 41 2 600 809 - © 09/08 BMW AG