Bosch Appliances Security Camera 5000 User Manual

FLEXIDOME 5000 AN

Connection and set-up | en

Bosch Security Systems

Installation Manual

AM18-Q0648 | v1.0 | 2013.03

Before adjusting the focal length or focus, place the lens 

adjustment cap on the lens to ensure that the image sharpness 

is the same as when the dome is in place. 

1.

Connect a monitor or other display device to either the 

camera’s BNC connector or to the optional cable (S1460) 

on the monitor jack. (If S1460 is connected, there is no 

signal on the BNC connector.)

2.

Press and hold the menu/select (center) button until the 

Install menu appears.

–

The Set focus item is highlighted. Do not change this 

selection as the camera is now in a special mode for 

adjusting focus.

3.

To set the field of view of the varifocal lens, loosen the 

focal length screw and turn the mechanism until the 

required view is displayed on the monitor. (Image goes out 

of focus.)

4.

Focus the image on the monitor by loosening the focus 

screw and turning the mechanism until the image is in 

focus.

5.

Re-adjust the focal length if necessary.

6.

Repeat these two adjustments until the desired view is in 

focus.

7.

Tighten both screws.

8.

Use the navigation buttons to move to Exit and press the 

center button until the menu disappears.

9.

Remove the lens adjustment cap from the lens and 

disconnect the monitor.

When using the camera at low temperatures, set the heater 

setting to Auto in the Install menu. The heater turns on at 

ambient temperatures below 0°C (+32°F).