Bosch Dual-Fuel Slide-In Range User Manual

Installation

English 17

If using rigid pipe, skip to “Rigid Pipe Method” on page 19.

1. Install male 1/2” flare adaptor at the 1/2” NPT internal thread of the range 

inlet. Use a backup wrench on the elbow fitting to avoid damage.

2. Install male 1/2” or 3/4” flare union adapter on the internal thread of the man-

ual shutoff valve.

3. Connect flexible metal appliance connector.

1. Make sure circuit breaker is off and then plug range cord into electrical outlet.
2. Connect flexible connector at gas inlet valve.

1. Line up range in front of opening.
2. Measure back left corner of opening from floor to top of countertop.
3. Measure back left corner of range to bottom of cooktop trim. Adjust leveling 

leg until this height is the same as the corner dimension.

4. Repeat in right back corner.
5. Adjust front leveling legs so that the bottom of the cooktop trim is ½" higher 

than the corresponding countertop surface.

Letter

Item

A

Gas Shut Off Valve

B

Regulator

C

Flexible Connector

Before you plug in an electrical cord, be sure all controls are in the 
Off position.

A

B

C