Bosch Appliances Home Security System D7212G User Manual

Page of 68
D7212G Operation and Installation Guide
D7212G
Page 11
© 2003 Bosch Security Systems
4998138544C
1.3.2
Tips, Notes, Cautions and Warnings
Throughout this document helpful tips and notes will be presented concerning the entire application and/or programming
the unit. They will be set off as follows:
Application
Note
Application Notes should be heeded for successful operation and programming. Helpful tips and/or shortcuts may
be included here.
CAUTION
Cautions the operator that physical damage to the equipment or improper execution of the program may occur.
WARNING
Warns of possible of physical damage to the operator, equipment and/or proper execution of the program.
1.4
FCC Rules
1.4.1
Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
Operation and Installation Guide, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
1.4.2
Part 68
This equipment complies with Part 68 of FCC rules. A label contains, among other information, the FCC registration
number and ringer equivalence number (REN). If requested, this information must be provided to the telephone company.
The Bosch Security Systems D7212G Control/Communicator is registered for connection to the public telephone network
using an RJ38X or RJ31X jack.
The ringer equivalence number (REN) is used to determine the number of devices that may be connected to the telephone
line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENs should not exceed five (5). To be certain of the number of devices that may be connected
to the line, as determined by the RENs, contact the telephone company to determine the maximum REN for the calling area.
If trouble is experienced with the D7212G Control/Communicator, please contact Bosch Security Systems Customer Service
for repair and/or warranty information. If the trouble is causing harm to the telephone network, the telephone company
may request that the equipment be removed from the network until the problem is resolved. User repairs must not be made,
and doing so will void the user’s warranty.
If the D7212G Control/Communicator causes harm to the telephone network, the telephone company will attempt to notify
you in advance. If advance notice isn’t practical, the telephone company will notify you as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone company will provide advance notice in order for the necessary
modifications to be made in order to maintain uninterrupted service.
This equipment cannot be used on public coin service provided by the telephone company. Connection to Party Line service
is subject to state tariffs. (Contact your state public utilities commission for information.)
FCC Registration Number:
AJ9MUL-46532-AL-E
Service Center in USA:
National Repair Center
Ringer Equivalence:
0.1B
130 Perinton Parkway
Fairport, NY  14450-9199
(585) 223-4220
Introduction