BMW K 1100 LT/RS User Manual
11.41
Installing combined oil-water pump
•
Apply a thin coat of 3-Bond 1209 to the sealing
faces, which must be free of oil and grease.
faces, which must be free of oil and grease.
•
Place O-ring on water passage.
•
Insert the input pinion into the output shaft with
an oiled O-ring.
an oiled O-ring.
•
Attach the pump housing and insert the screws
loosely at first.
loosely at first.
L
Note:
Turn the crankshaft several times in order to centre
the gearwheels, at the same time gradually tighten-
ing the retaining screws.
the gearwheels, at the same time gradually tighten-
ing the retaining screws.
•
Tighten the retaining screws fully.
X
Tightening torque:
Pump housing to crankcase........................... 7 Nm
•
Insert the wire for the oil pressure telltale and
temperature display through the housing and
connect it.
temperature display through the housing and
connect it.
•
Apply a thin coat of 3-Bond to the sealing faces
on the cover and housing, which must be free
from oil and grease.
on the cover and housing, which must be free
from oil and grease.
•
Place the housing cover in position and tighten it.
X
Tightening torque:
Cover to pump housing.................................. 7 Nm