BENDIX SD-13-4869 User Manual

Steering Angle Sensor Tests
1 .  Measure resistance between input voltage and ground 

at the sensor wiring harness connector.

  Verify continuity between ECU and SAS-60 and 

YAS-60.

2 .  Verify wiring between the Steering Angle Sensor and 

the ECU.

 

 

4 

7 

Verify Continuity

 

3 

8 

Verify Continuity

Looking into wire harness connector

3 .  Verify wiring between the Steering Angle Sensor and 

power/ground.

 

  4  to Voltage & Ground 

Verify open circuit (no continuity)

  3  to Voltage & Ground 

Verify open circuit (no continuity)

4 .  To perform a calibration procedure of the Steering Angle 

Sensor, ACom

®

 Diagnostics V4.0 or higher is required.  

Using the program, select the “Configuration” option, 

followed by the “Calibrate” option.  The following screen 

should be displayed.

5 .  Follow the prompts to perform a calibration of the 

Steering Angle Sensor.

6 .  To test the Steering Angle Sensor, ACom V4.0, or 

higher, is required.  Using Bendix ACom V4.0 or higher, 

select the “Component Test” option, followed by the 

“ESP Test” option.  The following screen should be 

displayed.

7 .  Follow the prompts to perform a test of the Steering 

Angle Sensor.

 

 

SAS 

2 

Voltage Input

 

 

1 

Ground Input

 ECU
  X4 

11 Power 

  12 Way 

10  Common

SAS Connector

(Note: When checking for voltage at YAW/LAS & SAS, the voltage will only be present momentarily at key ON.).