Bay Technical Associates BayTech DS62 User Manual

28 

IMPORTANT: For network access, you must configure the IP addresses, Subnet Mask, and 
Gateway Address. The module must be reset for network changes to take effect. 

 

The IP address is the network address assigned by your network manager for your network.  The IP 
Address consists of four bytes, each byte ranging from 0 to 255. This parameter must be programmed 
before the DS is accessible via the network.  

 

Select 1) to enter the IP Address. Failure to enter the address in the decimal form causes the DS to 
display the following until it is entered correctly. Default Module IP Address is 0.0.0.0. 

NOTE: There should be no active connections while configuring the DS module.  The unit 
should be reset upon completion of configuration. 

 

 

The Subnet Mask is a bit mask that identifies the network portion of the IP address, allowing the DS to 
determine whether to send a packet directly to the client or to a gateway.  The Subnet Mask consists of 
four bytes, each byte ranging from 0 to 255.  This parameter must be programmed before the DS-
Series can be accessed through the network.