Bay Technical Associates BayTech DS62 User Manual
DS62-Network, DS62-MD4 Network/Modem Host Module
29
Select 2) to enter the Subnet Mask followed by <cr>. Failure to enter the address in the decimal form
causes the DS to display the following until it is entered correctly. Default Subnet Mask is 0.0.0.0.
causes the DS to display the following until it is entered correctly. Default Subnet Mask is 0.0.0.0.
Gateway Address
The Gateway is the address of a router to connect to other parts of a network. The Gateway address
consists of four bytes, each byte ranging from 0 to 255. If your network uses gateways, this parameter
must be programmed before the DS can be accessed through the network.
consists of four bytes, each byte ranging from 0 to 255. If your network uses gateways, this parameter
must be programmed before the DS can be accessed through the network.
Select 3) to enter the Gateway address. Failure to enter the address in the decimal form causes the DS
to display the following until it is entered correctly. Default Gateway address is 0.0.0.0.
to display the following until it is entered correctly. Default Gateway address is 0.0.0.0.
Inactivity Timeout
This option enables the DS to disconnect after the programmed amount of time, if there is no activity.
Default is 0 (DISABLED). The enabling input can be from 1 to 120 minutes.
Default is 0 (DISABLED). The enabling input can be from 1 to 120 minutes.
Carriage Return Translation
This option determines what the telnet processor will do with the line-feeds and nulls after a carriage
return is sent. Enable tells the DS Telnet processor to strip line feeds or nulls Translation after the
carriage returns. Disable allows the characters to pass through. Default is “DISABLED”.
return is sent. Enable tells the DS Telnet processor to strip line feeds or nulls Translation after the
carriage returns. Disable allows the characters to pass through. Default is “DISABLED”.
Break Length
Users may configure the DS for a break length of 1 - 1000 milliseconds. In a Telnet session with the
DS through the serial port of a DS74, send a Telnet break command (0xF3) to the DS, the serial port
will send a break signal of the programmed duration. Default is 350 milliseconds.
DS through the serial port of a DS74, send a Telnet break command (0xF3) to the DS, the serial port
will send a break signal of the programmed duration. Default is 350 milliseconds.
Enter Subnet Mask in dotted decimal form :
Enter Gateway address in dotted decimal form :
Connection Inactivity Timeout is 0 minutes
Enter timeout, in minutes (<=120, 0 to disable) :
Enter 0 to disable or a number between 1 and 120 (inclusive) to set the timeout.
Enter timeout, in minutes (<=120, 0 to disable) :
Enter 0 to disable or a number between 1 and 120 (inclusive) to set the timeout.
Carriage Return Translation is.... Enabled
Enable ? (Y/N), CR for no change) :
Enable ? (Y/N), CR for no change) :
Break Length is (msec)............ 350
Enter break length, in milliseconds (<=10000, 0 to disable) :
Enter break length, in milliseconds (<=10000, 0 to disable) :