Tekkeon ET6000 User Manual
4
Setting Up ezSpeak
Before using ezSpeak, you must:
• Charge ezSpeak
• Pair ezSpeak to your mobile phone
• Mount ezSpeak to your visor (for in car use)
Directions for each of these activities are provided in the following three sections. Once these steps are
completed, you will be ready to use ezSpeak!
completed, you will be ready to use ezSpeak!
Charging ezSpeak
Before using ezSpeak, you must charge the device for a minimum of two hours. When fully charged, the
battery provides up to ten hours of talk time and up to 220 hours of standby time. When the battery is at
less than 5% of capacity, the low battery icon will appear on the display.
battery provides up to ten hours of talk time and up to 220 hours of standby time. When the battery is at
less than 5% of capacity, the low battery icon will appear on the display.
1. Plug the car charger into the charging jack on the end of ezSpeak.
2. Plug the car charger into the 12V charging outlet in your car.
The red charging LED will light while
ezSpeak is charging. When the device is fully charged (in approximately 2 hours), the red LED will
turn to to green.
turn to to green.
3. Unplug the car charger from the charging outlet.
et6000_ug_fnl 10/26/06 4:17 PM Page 4