jWIN ILuv i903 User Manual

Noise-Canceling Headset w/ Bluetooth wireless technology       V10M10_IM_EN_12072006 

www.i-Luv.com 

 

The i903 can be used with an audio device that is not designed to support Bluetooth 
wireless technology using the supplied wireless audio transmitter (dongle). In order to 
answer and place phone calls while using the dongle, it is important to pair the mobile 
phone first. After pairing the mobile phone according to the previously-listed instructions, 
follow these directions to set the pair the i903 with the dongle. 
 
1.   To set the i903 into pairing mode, make sure to turn on the switch located on the left 

ear piece. Then press and hold the Multi-Function button for five (5) seconds. 

 
2.  Press and hold the On/Off button on the dongle for 

approximately five (5) seconds. 

 
3.  Both i903 and Dongle will display flashing Blue and red 

lights, indicating that both are in pairing mode.  

 

4.  Place the headset near the 

dongle when both are in 
pairing mode. 

 
 

5. When 

the 

alternating red 
and blue blinking 
lights on both 
devices change 
to a blue blinking 
light ONLY, 
pairing is 
complete.  

 
6.  Plug the 3.5mm end of the dongle into the 

headphone jack of an audio device and enjoy 
music playback wirelessly through the i903 
stereo headphones. 

 
Note: Only the volume can be controlled on the 
i903 when using the dongle. All other functions 
(skip, stop, forward, etc.) must be controlled using 
the controls on the audio device itself.