GE RV60 LED System Installation Guide
• Tuck wires underneath Wire Cover before placing it over the
End Cap and Mounting Tab.
• Attach Wire Cover to LED Light End Cap by installing a
• Attach Wire Cover to LED Light End Cap by installing a
M2.9x10 pan head tapping screw (provided) through the
hole in the End Cap and Mounting Tab using an installation
torque of 3 lbf-in.
NOTE:
NOTE:
Tighten slowly until fully seated, do not over tighten or
strip the threads.
• Repeat these steps for the mullion on the other end of the case.
• Repeat these steps for the mullion on the other end of the case.
Attach Covers to End Cap
8
CAUTION/ATTENTION
Risk of electrical shock. Plastic cover is needed to protect electrical wires from tampering and accidental contact. / Risque de choc
électrique. Le couvercle en plastique est requis pour assurer une protection adéquate contre l'accès aux fils et les contacts accidentels.
End Cap
Wire Cover
M2.9x10 pan
head tapping
screw
• The outer lens and the plastic housing should be cleaned
periodically with a mild liquid dish detergent.
• Do not use chemical cleaners to clean the lens.
• Keep the outside clean. Wipe with a clean cloth lightly
• Do not use chemical cleaners to clean the lens.
• Keep the outside clean. Wipe with a clean cloth lightly
dampened with mild liquid dish detergent. Dry with a
clean, soft cloth.
LED Refrigerated Display Lights – Cleaning Instructions
9
WARNING/AVERTISSEMENT
Risk of electrical shock. Disconnect power to LED Lights before any cleaning operation.
Risque de choc électrique. Débranchez l'alimentation des éclairages à LED avant toute opération de nettoyage.
• Do not wipe the lens with a soiled dish cloth or wet towel.
These may leave a residue that can damage the finish.
• Do not use scouring pads, powdered cleaners, bleach or
• Do not use scouring pads, powdered cleaners, bleach or
cleaners containing bleach because these products can
scratch and damage the finish.
GE Lighting Solutions • 1-888-MY-GE-LED
(1-888-69-43-533)
• www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Immersion is a trademark of GE Lighting. The GE brand and logo are trademarks of the General Electric Company.
Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
© 2013 GE 64140 121013
This product is intended solely for the use of commercial refrigerated, display or
case lighting and is not intended for use in any other application.