GE RV60 LED System Installation Guide
imagination at work
GE
Lighting
Retrofit Installation Guide
BEFORE YOU BEGIN
Read these instructions completely and carefully.
CAUTION/ATTENTION
Risk of injury. While performing installations described, gloves, safety
glasses or goggles should be worn. / Risque de blessure. Lors de
l'exécution des installations décrites, des gants, des lunettes de sécurité
ou des lunettes de protection doivent être portées.
glasses or goggles should be worn. / Risque de blessure. Lors de
l'exécution des installations décrites, des gants, des lunettes de sécurité
ou des lunettes de protection doivent être portées.
• The power supply must be supplied with 100-240 VAC,
50/60 Hz, and connected to an individual properly grounded
branch circuit, protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
branch circuit, protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
• Wiring must be 2 wire with ground and rated for 75°C (167°F).
• Do not overload driver, follow installation instructions for the
• Do not overload driver, follow installation instructions for the
GEPS6000NCMUL-SY or GEPS6500NCMUL-SY.
• Ensure that all connection points are sealed for damp
location using the appropriate method per the NEC or local
electrical code.
electrical code.
PREPARE ELECTRICAL WIRING
Electrical Requirements
WARNING/AVERTISSEMENT
Risk of electrical shock. Disconnect power before servicing or installing product.
LED Retrofit Kit Installation requires knowledge of luminaires electrical systems. If
not qualified, do not attempt installation. Contact a qualified electrician. Install this
kit only in the luminaires that have the construction features and dimensions shown
in the photographs and/or drawings. / Risque de choc électrique. Couper le courant
avant de réparer ou installer le produit. LED Retrofit Kit d’installation nécessite la
connaissance des systèmes luminaires électriques. Si vous n’êtes pas qualifié, ne
tentez pas l’installation. Contactez un électricien qualifié. Installez ce kit seulement
dans les luminaires qui ont les caractéristiques de construction et les dimensions
figurant sur les photographies et / ou des dessins.
Grounding Instructions–Cable Direct
• This lighting system must be connected to a grounded metal,
permanent wiring system, or an equipment grounding conductor
must be run with the circuit conductors and be connected
permanent wiring system, or an equipment grounding conductor
must be run with the circuit conductors and be connected
to the equipment grounding terminal.
LED DRIVER COMPATIBILITY
This system is compatible with GEPS6000NCMUL-SY or
GEPS6500NCMUL-SY LED Driver. Please refer to the separate
LED driver installation guide for appropriate wiring connections.
GEPS6500NCMUL-SY LED Driver. Please refer to the separate
LED driver installation guide for appropriate wiring connections.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
• Installation to be performed by factory trained service
personnel only.
• For use inside a commercial refrigeration case with packaged
foods only.
• Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
• Before installing, servicing or cleaning unit, switch power off
at the service panel and follow appropriate lock out/tag out
safety procedures
• For use inside a commercial refrigeration case with packaged
foods only.
• Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
• Before installing, servicing or cleaning unit, switch power off
at the service panel and follow appropriate lock out/tag out
safety procedures
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS shown
throughout these instructions.
throughout these instructions.
IMMERSION
TM
LED Refrigerated Display Lighting
Vertical Cases
RV60 Series
End Mullion LED Lights
48-inch: GELT604850EDR-SY/-SB (85743/85746), GELT604850EDL-SY/-SB (85744/85747), GELT604840EDR-SY/-SB (85749/85752),
GELT604840EDL-SY/-SB (85750/85753), GELT604835EDR-SY/-SB (85755/85758), GELT604835EDL-SY/-SB (85756/85759)
60-inch: GELT606050EDR-SY/-SB (85700/85703), GELT606050EDL-SY/-SB (85701/85704), GELT606040EDR-SY/-SB (85706/85709),
GELT606040EDL-SY/-SB (85707/85710), GELT606035EDR-SY/-SB (85712/85715), GELT606035EDL-SY/-SB (85713/85716)
67-inch: GELT606750EDR-SY/-SB (85720/85723), GELT606750EDL-SY/-SB (85721/85724), GELT606740EDR-SY/-SB (85726/85734),
GELT606740EDL-SY/-SB (85727/85735), GELT606735EDR-SY/-SB (85737/85740), GELT606735EDL-SY/-SB (85738/85741)
Description Code (Single Unit Product Number/10-Pack Product Number)