Luxor TUTV2500 User Manual

Using your DTR Remote to control your TV

The DTR remote control is capable of controlling the common functions of your TV. Locate

the “Remote control TV set-up codes” sheet from your accessories and find your make of TV

on the list. Note the four digit number(s) applicable to your TV. on the DTR remote press TV,

now press and hold oK

and

together. The TV

button will flash twice. Now enter the 4

digit code relating to your make of TV. Again the TV

button will flash twice. if an invalid code

is entered, the TV

button will only flash one long flash.

Make sure that the entered code is the right one for your TV by

pressing the ‘active’ buttons from the list below. if your TV does

not respond, repeat the sequence with the next available code

in the table. once you are sure that the code is correct you can

write it down in the box to the right and on an identical label on

the inside battery door of your DTR remote control.

insert the batteries into the handset as shown. point the remote

control at the DTR and press the DTR button. The DTR button

will flash once to confirm that the remote control is working

correctly.

important information regarding the batteries

Do not mix different types of batteries or new and old batteries.

Do not use re-chargeable batteries. Do not throw batteries into

a fire, do not recharge them. Remove the batteries from the

remote control if you are not going to use it for several weeks.

immediately remove any leaking batteries. Take care in doing

this, as leaking batteries may cause burns to the skin or other

physical injury.

inserting the batteries

please respect the environment and prevailing regulations.

Before you dispose of batteries ask your dealer whether they

are subject to special recycling and if they accept them back.

Controlling your TV set

Sets the remote control unit in TV mode (by pressing once)

and enables you then to control your TV set.

Switches the TV set on or off.

Vol. +/-

TV volume control.

Switches sound off or on again.

Ch +/-

Switches channel or selects an AV socket.

Selects an AV socket.

0 to 9

Change channel or enters digital values.

TeXT

Access Teletext pages (on / off).

‘play’ button

Access Teletext pages (off).

Colour buttons

enables you to use the Teletext function on TV sets.

Remote Control

information