Luxor TUTV2500 User Manual

Safety information

power cord (mains lead)

Do not place the product where a piece of furniture or other heavy object could trap the

power cord (mains lead). handle the power cord by the plug. Do not pull out the plug by

tugging the cord and never touch the power cord when your hands are wet as this could

cause a short circuit or electric shock. Never make a knot in the cord or tie it with other cords.

The power cords should be routed in such a way that they are not likely to be stepped on.

A damaged power cord can cause fire or give you an electrical shock. Check the power cord

periodically to see if it is damaged. if it is damaged, please ask an approved service agent to

replace it.
for your own safety read following instructions carefully before attempting to

connect this device to the mains. This unit is designed to operate on a 220V-240V

AC – 50hz supply only. Connecting it to other power sources may damage it. ensure

that the supply corresponds to the information on the rating label on the bottom

of the unit. This component system may be fitted with a non-rewireable plug. if it is

necessary to change the fuse in a non-rewireable plug, the fuse cover must be refitted.

if t he fuse cover becomes lost or damaged, the plug most not be used until a replacement, available

from the manufacturer, is obtained. it is important that the colour of the replacement fuse cover

corresponds with the colour marking on the base of the plug. if the plug needs to be changed

because it is not suitable for your socket, or it becomes damaged, it should be unplugged

then cut off and the fuse removed immediately. please dispose of the plug safely and out

of reach from children. Under no circumstance should the cut-off plug be inserted into a

mains socket outlet due to high risk of

electric shock. Then fit an appropriate

plug carefully following the wiring

instructions shown below.

important

The wires in the mains plug should

be connected as shown in the

diagram. The colours of the wires

in the mains lead of the unit may

not correspond with the coloured

markings identifying the terminals in

your plug. Connect them as follows:
• The wire which is coloured

blue must be connected to the

terminal which is marked with the letter ‘N’ or coloured black.

• The wire which is coloured brown must be connected to the terminal which is marked

with the letter ‘L’ or coloured red.

• There should be no connection to the earth terminal of your plug.

if you use a 13 Amp (BS1363) plug, you will need a 5 Amp fuse.

• The mains plug is the disconnect device and therefore must remain readily operable.