LevelOne Network Hardware 11g PoE Wireless Access Point User Manual

Setup 

41 

This determines how quickly a Wireless Station will be 
considered "Disassociated" with this AP, when no traffic is 
received. Enter the desired time period. 

Enter the preferred setting between 256 and 2346. Normally, 
this can be left at the default value. 

Enter the preferred setting between 20 and 1000. Normally, this 
can be left at the default value. 

Enter the preferred setting between 256 and 2346. Normally, 
this can be left at the default value. 

Select the desired option. The default is "Long". The "Short" 
setting takes less time when used in a good environment. 

Select the desired power output. Higher levels will give a 
greater range, but are also more likely to cause interference with 
other devices. 

If your Access Point has only 1 antenna, there is only 1 option 
available. If your Access Point has 2 antennae, select the option 
which gives the best results in your location. 

Select the desired option. The default is CTS-only. 

Enable or disable this setting as required. 

The Protection system is intended to prevent older 802.11b 
devices from interfering with 802.11g transmissions. (Older 
802.11b devices may not be able to detect that a 802.11g 
transmission is in progress.) Normally, this should be left at 
"Auto".