Shindaiwa EC7600 User Manual

10

EC7500.20A

EC7500.19

Instruction

Manual

Engine Unit

Tool Set

Belt

Guard

Hex

Wrench

1. Select a cut-off wheel for your work

according to the following chart.
Refer to the wheel manufacturer’s
manual for additional information.

Inner bore: 0.78" (20mm),

0.86" (22mm), 1.0" (25.4mm)

Wheels for EC7500

Abrasive: 305mm outer diameter
Diamond: 320mm outer diameter

Wheels for EC7600

Abrasive: 355mm outer diameter
Diamond: 360mm outer diameter

Before assembling, make sure you
have all the components required for a
complete unit. This unit consists of the
items shown in Figure 6.

Carefully inspect the engine unit for

damaged or loosen bolts. If you find
any damage or missing items, check
with your dealer.

This unit is
equipped with a
0.86" (22mm)
wheel collar.
Wheel adapters
for 20mm and
25.4mm cut-off
wheels are
located in the
tool set. Before
mounting a
wheel, deter-
mine its arbor
diameter. If it is
necessary to
replace the
collar, remove the snap ring on the
arbor, install the correct size arbor
collar, and then replace the snap ring.

Use of the incorrect collar size
may lead to wheel failure and unit
failure that could result in serious
injury.

2. Make sure the ON-OFF switch is

Off and the engine is stopped.

3. Insert a hex wrench into the hole in

the belt guard to prevent the arbor
from turning. See Figure 7.

EC7500.45

Snap

Ring

Flange

Drive Shaft

Collar

EC7500.49

20mm

Collar

22mm

Collar

25.4mm

Collar