Shindaiwa EC7600 User Manual

12

EC7500.22

7. Grip the recoil starter handle with

your right hand, pull the starter
cord slowly until you feel the starter
engage, then…

8. …start the engine by pulling the

starter cord upward rapidly.

■

The recoil starter can be
damaged by abuse.

■

Never pull the starter cord to its
full length.

■

Always engage the starter
before cranking the engine.

■

Always rewind the starter cord
slowly. Do not just let go of the
cord.

9. When the engine fires, push the

choke in to its original position
(choke open).

10. If the engine does not continue to

run, pull the recoil again.

11. As the engine starts, clear excess

fuel from the combustion chamber
by revving the engine several times.

The throttle trigger can not be moved
without first depressing the lockout
lever.
Operating the throttle will automati-
cally disengage the fast idle setting.

12. Let the engine run at idle speed for

2-3 minutes to warm up.

EC7500.21

■

Before starting the engine,
place the unit on a clean, level
surface. Make sure you have
good secure footing and always
keep a firm grip on the unit.

■

Move at least 10 feet (3m)
away from the fueling site
before starting the engine.

■

Make sure the cut-off wheel is
well clear of obstacles. The cut-
off wheel may rotate when the
engine starts.

■

Keep bystanders well away.

■

Never start the engine without a
cut-off wheel installed.

Starting the Engine When the Engine is Cold

Primer

Pump

Choke

1. Turn the on-off switch On.

2. Depress the primer pump a few

times repeatedly until the primer
pump is almost filled with fuel.
See Figure 9.

3. Push the decompression valve In.

4. Pull the choke all the way out

(choke closed). The throttle will
automatically be set to fast idle.
See Figure 9.

5. Place the unit on firm ground.

6. Secure the unit by placing your

right foot inside the rear handle
and your left hand on the front
handle. See Figure 10.