Pertech A470e User Manual
A470e Users Guide
Pertech® 2006
16
Hardware
Mechanism Model:
A470E-48X1
Independent Validate
A470E-48X0
Receipt Only
A470E-4812
Concurrent Validate With Rewind
A470E-4872
Concurrent Validate
A470E-4874
Validate Only
The Mechanism Model Option is Not Selectable in Configuration Mode.
Setup for this option is done via Command Codes. Setting the mechanism
model incorrectly could result in damage to the printer.
Please contact your Pertech service representative if you are unsure of the
model your printer should be set to.
LED Usage
Status / Slip
Power / Paper Low
Validation Clamp: (A470 Mode Only).
Closed
Open
Form Insert Wait (ACL Mode Only):
0-15 Minute
Paper Low Sensor:
Enabled
Disabled
Paper Out Sensor
Disabled
Equals Paper Low
Virtual Paper Out
2FT
4FT
6FT
8FT
10FT 12FT
At the completion of the Configuration Report Self Test, the printer will prompt for access to the
Configuration Mode, let the option for the Configuration Mode expire. The printer will then prompt
for the Extended Self Test. To begin the Extended Self Test press the Paper Feed Button within
10 seconds. If the button is not pressed within this time limit, the printer will resume normal
operation.
The Extended Self Test performs a printhead pin firing test, character drop test, checks the
vertical line adjustments, fonts, validation clamp, pitches and character sets.
Extended Self Test