ONKYO A-9155 User Manual

13

With 

 (Remote Interactive), you can control your 

-compatible Onkyo CD player, Tuner, and so on 

with the A-9355/A-9155’s remote controller.
If you connect other Onkyo components to the 
A-9355/A-9155 with the appropriate 

 and audio 

cables, you can use the following system functions. 

 

cables are special cables solely for use with Onkyo 
products (no 

 cables are supplied with the 

A-9355/A-9155).

When you set the A-9355/A-9155 to Standby, all con-
nected components will go on Standby as well (the 
A-9355/A-9155’s POWER switch must be set to ON for 
this to work).

Direct Change
When playback is started on an audio component con-
nected via 

, the A-9355/A-9155 will automatically 

select that component as the input source.

Remote Control Operation
You can control all components in your system by using 
the A-9355/A-9155’s remote controller. See page 8 and 
9 for more information.

Notes:
• Push each plug in all the way to make a good connec-

tion.

• A-9355: The A-9355 has two 

 jacks. If you want 

to connect two or more audio components to the A-
9355, it is advisable to connect any of two compo-
nents directly to the A-9355 for better audio quality, 
in stead of linking all the components using the daisy 
chain method.

• Use only dedicated 

 cables for 

 connections 

(no 

 cables are supplied with the 

A-9355/A-9155).

• The A-9355 has two 

 jacks. They’re all the same, 

so you can use either of them.

•

 jacks should be connected only to Onkyo compo-

nents. Connecting them to another manufacturer’s 
component may cause the A-9355/A-9155 to mal-
function.

• Some components may not support all 

 functions. 

See the manuals supplied with your other Onkyo 
components for more information.

The A-9355/A-9155 has a switched AC OUTLETS on 
its rear panel. These can be used to connect the power 
cord of another audio component that you intend to use 
with the A-9355/A-9155.
After you power on the A-9355/A-9155, you can feed or 
shut off power to the connected component by turning 
on or off the remote controller switch. Use the AC outlet 
of the A-9355/A-9155 to feed only components that 
have no STANDBY/ON function, like Onkyo DX-7355 
CD player. For Onkyo products equipped with 

 ter-

minals that have a STANDBY/ON function, allocate a 
normal outlet that is energized on a steady basis.

Note:
Do not connect any other devices than audio compo-
nents.

Caution:
Make sure that the maximum power requirement of the 
component connected to the AC OUTLETS do not 
exceed the capacity printed on the A-9355/A-9155’s 
rear panel (100W).