DMP Electronics Inc. Smoke Alarm XR2400F User Manual

8

User Code Level: All users.

Function: Displays the current condition of internal system hardware.

System Status displays the condition of the panel's AC power, battery
power, and optional panel tamper. When System Status is selected,
each monitor is displayed followed by OKAY or TRBL (Trouble) to
indicate the current condition.

1. Access the User Menu.

2. Press COMMAND until SYSTEM STATUS? displays.

3. Press any SELECT key. The display starts listing each system

monitor and status.

For example: AC POWER  -  OKAY

Below are the System Monitor displays:

   Display

What it monitors

=

AC power

=

Battery power

=

Panel enclosure tamper

These are followed by either OKAY or TRBL (trouble).

If TRBL is displayed, call the service department for assistance.

4. The system then displays its firmware version (for example,

VER_105_7/24/00), the panel model (MODEL XR2400F), then
exits the User Menu.

User Code Level:  4 and above.

Function: System Test is used to test the battery, alarm bell or siren,
and communication to the central station. The System Test function
begins automatically as soon as you select it.

1. Access the User Menu.

2. Press COMMAND until SYSTEM TEST? displays.

3. Press any SELECT key. The system test begins automatically

and the display shows:

1) BELL SOUNDING during a two second bell test, then:

2) BATTERY  - OKAY or BATTERY   - TRBL to indicate the

condition of the battery, then:

* 3) TRANSMIT  TEST and ATTEMPT  NO : 1 during the

transmit test, then:

4) TRANSMIT  OKAY or TRANSMIT FAILED to show the

results of the transmit test, then:

5) TEST END to indicate the System Test is complete.

6) You can end the transmit test by pressing the ARROW key.

* The transmit test does not operate on local systems.

The TEST function key can only be used after the keyswitch has been
turned to the “Enable” position.