DMP Electronics Inc. Smoke Alarm XR2400F User Manual
10
User Menu
SYS STAT
(system status)
NO
ALM SLNC
(alarm silence)
NO
SYS TEST
(system test)
SNSR RST
(sensor reset)
NO
USR CODE
(user code)
NO
TIME
(day, date, and time)
NO
OUTPUTS
(outputs on/off)
NO
DIS EVNT
(display events)
NO
ZN STATS
(zone status)
NO
TEMP CODE
(temporary code)
*
NO
SERV REQ
(service request)
NO
FIRE DRIL
(fire drill)
NO
NO
Programming Custom User Codes
In addition to the preset authority levels, you can also create custom
authority levels by selecting the CUSTOM option at the time the user
is being added to the system. This option allows you to assign specific
User Menu access to individual users.
authority levels by selecting the CUSTOM option at the time the user
is being added to the system. This option allows you to assign specific
User Menu access to individual users.
Adding User Codes
1. Access the User Menu.
2. Press COMMAND until USER CODES? displays. (NOTE: You
must have a level 9 authority. If you enter the User Menu with a
lower authority, the keyboard will not display USER CODES?.)
lower authority, the keyboard will not display USER CODES?.)
3. Press any SELECT key. ADD DEL CHG displays.
4. Press the SELECT key under ADD to add a new user code.
5. At the USER NUMBER:- prompt, enter a user number and press
COMMAND. The display changes to CODE NO:- .
6. Enter a user code of 3 to 5 digits and press COMMAND. The user
enters this number each time they make changes. If using
access cards, present the card instead of entering a code. The
code is displayed for four seconds. After the code is entered, the
display changes to USER NUMBER ###.
access cards, present the card instead of entering a code. The
code is displayed for four seconds. After the code is entered, the
display changes to USER NUMBER ###.
7. A 16 character name may be entered to identify the user. Press
any top row key to clear the current name. You may then enter
the new name. After the name is entered, press COMMAND.
the new name. After the name is entered, press COMMAND.
8. The display changes to LEVEL CUSTOM. Select LEVEL to
assign a standard set of authorized functions as outlined in the
User Code Authority Levels table on the previous page.
User Code Authority Levels table on the previous page.
9. At the LEVEL: - display, enter an authority level from 1 to 9.
Press COMMAND. The displays shows USER # ADDED.
10.Select CUSTOM to customize the functions you want the user to
access. This allows users to have certain capabilities outside of
a standard authority level. The following chart shows the custom
menu with default selections.
a standard authority level. The following chart shows the custom
menu with default selections.
* YES allows you to then enter the number of days (1 to 250) that
a temporary user code can operate. Default is 7 days. Temp
users are deleted from the system at 12:00 AM on the last day.
users are deleted from the system at 12:00 AM on the last day.
11.Press the ARROW key to exit the User Menu.
Note: It is recommended that user codes be enabled for only the
function shown above. Other burglary functions are available to add
to a user code, but are not relevant and, therefore, are not
recommended.
function shown above. Other burglary functions are available to add
to a user code, but are not relevant and, therefore, are not
recommended.