Bosch HES7052U Quick Setup Guide

English 13

• A risk of tip-over may exist if the appliance is not installed in accordance with 
these instructions.

• If the range is pulled away from the wall for cleaning, service, or any other rea-
son, ensure that the Anti-Tip Device is properly reengaged when the range is 
pushed back against the wall. In the event of abnormal usage (such as a person 
standing, sitting, or leaning on an open door), failure to take this precaution could 
result in tipping of the range. Personal injury might result from spilled hot liquids or 
from the range itself.

1. Adjust height of range and level by rotating the adjustable leg supports on the 

bottom of the range, using 1-1/4" (31.75 mm) wrench.

2. Measure to locate bracket position as shown below.

3. Secure bracket with 2 screws adequate for mounting surface, not included. 

(i.e.; for wood floor use wood screws for concrete floor use concrete anchors 
and screws). 

1. Move range close enough to the opening to plug into the receptacle.
2. Slide range into position ensuring that the left back leg slides under the anti-

tip bracket. Range will sit 3/4” (19.05 mm) away from back wall when properly 
installed.

3. Carefully tip range forward to ensure that the anti tip bracket engages the 

range back brace and prevents tip-over.

4. Turn on electrical power. Check range for proper operation as described in 

Use and Care Manual. 

adjustable leg

wrench

drawer

flush against 
cabinet wall

floor

cabinet wall

rear wall

anti-tippin g
device

 1 9/16" (39.7 mm)
from rear wall to center of screw hole