MAXTECH PCI Internal Voice/FAX/Data/Speakerphone Modem User Manual

10

&Q0 Modem in asynchronous mode

&S0 Force DSR Signal High (ON)
&S1

DSR is off in command mode, on in on-line
mode

&T_

&T0 Ends test in progress
&T1

Perform Local Analog Loopback Test

&U0 Enable Trellis Coding @ V.32
&U1

Disable Trellis Coding @ V.32

&V0 Displays Active and Stored Profile 0
&V1 Displays Active and Stored Profile 1
&V3 Displays relay and general-purpose I/O

status

&W_

&W0 Stores the active profile as Configuration

Profile 0

&W1 Stores the active profile as Configuration

Profile 1

&Y_

&Y1 Configuration Profile 1 active upon Power

on or reset

n=0-3 Store telephone number x into non-volatile

RAM

Displays the current Select Modulation
settings

Displays a list of supported Select
Modulation options

Select modulation where: a=V21, V22,
V22B, V23C, V32, V.32B, V34, V.34S,
V34B, V34BS, V90; b=0-1; c=0-33600;
and d=0-33600. A, b, c, d default=V90,
1, 300, 0. Parameter “a” specifies the
modulation protocol desired. Parameter
“b” specifies automode operations
where: 0=automode disabled, 1=
automode enabled. Parameter “c”
specifies the minimum connection data
rate (0-56600). Parameter “d” specifies
the maximum connection rate (0-56600),
where a 0 specifies highest possible
data rate, depending on the current DTE
rate.

%E0 V.22bis auto-retrain disabled