MAXTECH PCI Internal Voice/FAX/Data/Speakerphone Modem User Manual
11
%E1 V.22bis auto-retrain enabled
%E2 Enable line signal quality monitor and
%E2 Enable line signal quality monitor and
fallback/fallforward
%G_
%G0 Enable Auto Fall Forward/Back
%G1 Disable Auto Fall Forward/Back
%G1 Disable Auto Fall Forward/Back
-C_
-C0
Calling tone disabled
-C1
1300hz calling tone
-C2
V.8 and 1300hz calling tones enabled
3.5
MNP/V.42/V.42bis Commands
%A
n
Set auto-reliable fallback character to n
(where n = 0 to 127, ASCII). Requires the
\C2 setting. Default=13
(where n = 0 to 127, ASCII). Requires the
\C2 setting. Default=13
%C_
%C0 Disable MNP Class 5 data compression
%C1 Enable MNP Class 5 data
%C1 Enable MNP Class 5 data
compression
\A_
\A0
64-character maximum MNP block size
\A1
128-character maximum MNP block size
\A2
192-character maximum MNP block size
\A3
256-character maximum MNP block
size
size
\B
n
Send a 1/10 second line break to the
modem, where n = 1 to 9. At normal
connect, the default is 0
modem, where n = 1 to 9. At normal
connect, the default is 0
\C_
\C0
Do not buffer data during LAPM/
MNP handshaking
MNP handshaking
\C1
Buffer all data for 4 seconds, until
receiving 200 characters or until a packet
is detected
receiving 200 characters or until a packet
is detected
\C2
Do not buffer data; switch to normal
mode when fallback character is
detected
mode when fallback character is
detected
\G_
\G0
Disable DCE flow control
\G1
Enable DCE flow control
\J_
\J0
Disable serial port data rate
adjustment (keep high data rate
between DTE and modem,
regardless of modem-to-modem
data rate)
adjustment (keep high data rate
between DTE and modem,
regardless of modem-to-modem
data rate)
\J1
Enable serial port data rate adjustment
so serial data rate automatically adjusts
to match the modem-to-modem data rate
so serial data rate automatically adjusts
to match the modem-to-modem data rate
\K
n
Set break control, where n= 0 to 5.