LOEWE Wireless Speaker User Manual

After you have finished making the link, a message will appear 
on the screen.

Example 1 - successful link:

50Hz

50Hz

100Hz

100Hz

120Hz

END

OK

Sound components wizard

The transmitter and receiver module assignment has 

been completed successfully.

Proceed

Once the link has been made successfully, the LEDs in the 
transmitter and receiver module light up green continuously.

Example  - unsuccessful link:

50Hz

50Hz

100Hz

100Hz

120Hz

END

END

OK

OK

Sound components wizard

The assignment of the transmitter and receiver 

module was unsuccessful. You can try again with the 

      button or exit the wizard with the        button and 

restart it to change the speaker connection 

configuration if necessary.

Start Transmitter - Receiver assignment

Confirm OK and if necessary make further settings or 

close menu.

With other TV sets (other chassis than L710), configuration and connection are 
done manually. For this purpose, both modules have to be in connection status.

➠ 

Make sure that the units are set up correctly (page ). Depending on which 

TV  set  and  accessories  you  are  using,  either  the  connections  described  on 
page 4 or 5 are to be made.

Press  the  SET  button  on  the  transmitter  module  (page  18)  for  at  least 
3 seconds.

The green LED on the transmitter module flashes quickly.

Now, within the next two minutes, press the SET  button on the receiver module 
(page 19) for at least 3 seconds until the green LED display flashes quickly. Wait 
until the link is completed.

Once the link has been made successfully, the LEDs on the transmitter and 
receiver module light up green continuously.

You will find information on the LED displays on page 9.

➠ 

For TV sets with AC3 module, in the menu Sound components under sound 

playback via ... select the option Speaker system.

You can set the input sensitivity on the transmitter module in three steps to adjust 
the volume to the input signal.

Briefly press the SET button on the transmitter module (page 18). 

The  volume  can  be  adjusted  by  repeatedly  pressing  the  SET  button  in  the 
sequence 0 dB 

→ -6 dB → -1 dB → 0 dB etc.

 - 8