Smeg PGFU30X User Manual
Instructions for the User
7
3. USING THE COOKTOP
WARNING
FIRE HAZARD
FOR YOUR SAFETY:
- Do not let the burner flame extend beyond the edge
of the pan.
- Turn off all controls when not cooking.
NOTE: Before lighting the hob burners check that the flame
caps are in the correct position and that their burner caps are
in place, making sure that the holes A in the flame caps
correspond to the spark plugs and thermocouples.
Grid B should be used with Chinese woks.
caps are in the correct position and that their burner caps are
in place, making sure that the holes A in the flame caps
correspond to the spark plugs and thermocouples.
Grid B should be used with Chinese woks.
3.1 Ignition with safety device
Each knob has a symbol that shows the correspondent burner (the example here on the left shows the
front left burner).
front left burner).
The appliance is equipped with an electronic ignition.
- Just press and simultaneously turn the knob anti-clockwise to the low flame symbol
until the
burner switches on.
- Keep the knob pressed down for about 2 seconds to keep the flame lit and to activate the safety
device.
- After switching the burner on it is recommended that the knob is left in the minimum position for
approximately 20 seconds before adjusting it to the required temperature.
It may happen that the flame goes out when the knob is released. In this case repeat the operation, but
keeping the knob pressed down for a longer time.
keeping the knob pressed down for a longer time.
NOTE: If the flame goes out accidentally, after about 20 seconds the safety device will intervene and
block the gas flow, even when the tap is open.
block the gas flow, even when the tap is open.
REMEMBER: When the cooktop is in use, the entire cooktop area may become hot