Summit SEH26 Manual

FRAMING BEHIND DRYWALL

wood wall with minimum 
thickness of 8 mm

A

B

Ø8

Ø8

A

B

Ø10

Ø10

B

B

D

C

Ø10

Ø10

9

INSTALLING MOUNTING BRACKETS
1.

Construct wood wall framing with 
minimum thickness of 8 mm (0.3")  that 
is flush with interior surface of wall 
studs.
Make sure:
a.

the framing is centered over 
installation location;

b.

the height of the framing will allow 
the mounting brackets to be 
secured to the framing.

2.

After wall surface is finished, secure 
mounting brackets to framing using the 
assembly scheme.  

Fix the connector box to the motor junction plate 
with two 3,5 x 9,5 RYSB screws as shown.

To prepare the hanging plate for 
installation: 
Pull each tab upward, then retighten 
each screw.

Be sure the bulb is cool before trying to change it.

1

2

Disconnect the hood. 

Remove the aluminum cassette filter. 

In order to change the 50-watt halogen light bulb, refer to diagram below.  (1) Press 
down on the back part of the lamp holder and (2) turn it counter-clockwise.  

Replace old bulb with new one.  Turn in reverse direction when installing new bulb.

50-W Halogen bulb

Note:  Replacement bulbs can be purchased directly from SUMMIT by calling us at 
1-800-932-4267 or by going to our website at www.summitappliance.com/support.  
Have the model number of your range hood handy.

If you expect to have to move your range hood:
*

Keep original packaging.  Move your hood using original packaging; comply 
with moving instructions printed on the packaging.

If you do not have original packaging:
*

Do not put any load on the range hood.

*

Avoid any possible impacts.

*

Pack the hood in such a way as to prevent damage.

14