Whirlpool CEM2793BQ Installation Instruction

WARNING: To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.
IMPORTANT: Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

 

■

Only a 4" (102 mm) heavy, metal exhaust vent and clamps 

may be used. 

 

■

Do not use plastic or metal foil vent.

 

■

Recommended for best drying performance and to avoid 

crushing and kinking.

Flexible metal vent: (Acceptable only if accessible to clean)

 

■

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may result 

in reduced airflow and poor performance.

 

■

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7

3

⁄

4

 ft. (2.4 m).

NOTE: If using an existing vent system, clean lint from entire 

length of the system and make sure exhaust hood is not 

plugged with lint. Replace plastic or metal foil vents with rigid 

metal or flexible metal vents. Review “Vent System Chart” and, 

if necessary, modify existing vent system to achieve best drying 

performance.

 

■

45° elbows provide better airflow than 90° elbows.

 

■

Use clamps to seal all joints.

 

■

Exhaust vent must not be connected or secured with screws 

or other fastening devices that extend into interior of duct 

and catch lint. Do not use duct tape.

Moisture damage to woodwork, furniture, paint, wallpaper, 

carpets, etc.
Housecleaning problems and health problems.