Bosch NETP066SUC Manual

21

▯

The cooktop regulates the heating element 

temperature by turning the heat source on and off; this 

means that the reddish glow of the heat source 

beneath the heating element may not always be 

visible. If you select a low heat setting, the heat source 

is frequently off; at higher settings it is seldom off. The 

source turns on and off even at the highest settings.

▯

You may hear a quiet hum when the heating elements 

are in the heating phase. The heating elements may 

glow with different levels of brightness. Depending on 

the angle from which you are looking at the heating 

element, this glow may be visible over the marked 

edge of the heating element. These are technical 

characteristics. They have no effect on quality and 

function.

▯

Glass ceramic may have uneven areas on the surface 

due to the nature of the material itself. Because of the 

mirror-like finish on the cooking surface, even 

extremely small bubbles less than 1 mm in diameter 

may be visible. These bubbles will not have any 

adverse effect on the operation of the cooktop nor on 

the durability of the glass ceramic cooking surface.

▯

Depending on the countertop that is present in the 

kitchen, an uneven gap between the cooktop unit and 

the countertop can occur. For this reason, a flexible 

seal is provided around the entire cooktop unit.

Contact our Technical Service Department if your 

appliance needs repair. Our central Customer Service 

Center (see below) will also be happy to supply you with 

details on a center close to you.
E number and FD number:
When you contact our service, please have the Model(E) 

number and the FD number for your appliance available. 

You can find the identification plate with these numbers 

on the underside of the appliance and in the appliance 

booklet.
Questions? Please contact us. We look forward to 

hearing from you!

Display 

“

 and numbers A fault in the electronic system has 

occurred.

Turn the appliance off and back on at the fuse or cir-

cuit breaker. If the same fault occurs again, disconnect 

the appliance and call Technical Assistance Service.

Display 

”

 and numbers A fault has been detected.

The following table of error messages lists actions you 

can take to correct the problem

Fault

”ƒ

The element is too hot and has 

turned off.

Remove the pans from the elements. 

”ƒ

 disappears 

when you press the display, if the element has cooled 

down sufficiently. Wait a few minutes until the element 

has cooled down a bit. If 

”ƒ

 appears again after the 

element is turned back on, the cooktop is still too hot. 

Turn off the elements and allow them to cool further.

”…

The touch control zone is too hot.

Make sure that cookware is properly positioned on the 

element, and no hot objects are in contact with the 

touch control zone. Wait a few minutes until the touch 

control zone has cooled down. If 

”…

 appears after you 

turn on the appliance, call Technical Assistance Ser-

vice.

”ˆ

AutoChef™ is defective.

Confirm and close the error message by touching any 

area on the touch control zone. You can cook without 

AutoChef™. Contact Technical Assistance Service.

”‰

The element was in continuous use 

for too long.

The automatic time limitation has been activated. 

Touch any key. You can now turn on the heating ele-

ment immediately.

0DLQ6WUHHW6XLWH

,UYLQH&$

ZZZERVFKKRPHFRP