Fire Magic 22SC01CG6 Instruction Manual

3

REV 4 - 1405300810

L-C2-214

Read instructions carefully 
all the way through before 
beginning the installation.

1.  Dig a hole for the post and 

extension approximately 
18" deep and 10-12" in 
diameter.

Note:  The actual depth of 

the hole should be 
such that the cooking 
surface is 34-45" 
above ground level.

2.  Pour the concrete into the 

hole approximately 3-5" 
below ground level.

3.  While the concrete is still wet, carefully lower the grill 

post and attached extension into the hole. 

4.  Orient the grill per plan, then level the grill and 

support it so that it remains in position while the 
concrete dries.

This grill is designed FOR OUTDOOR USE ONLY.

Important: 

This unit is NOT insulated, and therefore during use it must be located with a minimum of 18" of side and back 

clearance from unprotected combustible materials such as wood, plastic, or stucco with wood framing.

CAUTION:  Metal edges are sharp; use adequate 

hand protection such as gloves when 
assembling and confi guring the grill.

Carefully unpack your grill and check the parts.

Important:  BEFORE USE, the patio mount base must 

be securely fastened to a stable, level 
surface to ensure the grill remains fi xed 
and upright at all times.

Locate the patio mount base in the planned grill 
location and mark the 4 holes. Drill the marked holes 
to a 1/2" diameter x 1 1/2" depth. Insert the lag shields 
(see PARTS LIST) into the holes, being sure that they 
are fl ush with the ground.

Align the holes on the patio mount base over the lag 
shields in the ground. Secure the base with the lag 
screws (see PARTS LIST) using a 7/16" nut driver.

1. 

Attach the extension to the bottom of the grill post so 
that the open portion is toward the back of the grill and 
the fi ve (5) holes in the extension line up with the fi ve 
(5) weld-nuts in the post.

2.  From outside the joined post 

and extension, insert one of the 
1/4 x 20-5/8" bolts (supplied) 
into each of the fi ve (5) bolt 
holes and tighten each using a 
7/16" socket driver or wrench 
(see Fig. 3-1).

Note:  There is one (1) hole on 

each side of the post, 
except the back, which 
has two (2) holes located on either side of the 
extension opening.

If installed under a patio roof, the grill area should be fully covered by a non-combustible chimney and exhaust 
hood. An exhaust fan with a rating of 1,000 CFM or more is necessary to effi ciently remove smoke and other 
cooking by-products from the covered area.