Fire Magic 42VH6 Installation Instruction

REV 2 - 1406051400

L-C2-387

13

The wall mount bracket must be installed into the spacer 
to assist in supporting the vent hood.

Fire Magic spacers are designed with pre-drilled holes and 
include screws for ease of bracket installation. 

1.  Center the bracket (from left-to-right) over the channel 

located on the front center of the Fire Magic Spacer.

2.  Using a medium Phillips screwdriver and the large 1/4-

20 screws supplied with the spacer, secure the bracket 
in place. The spacer has pre-drilled holes. See Fig. 13-1.

The bracket should be centered from left to right on the 
spacer. The horizontal position of the bracket center must be 
7.125" down from the top of the vent hood/spacer. Alignment 
notches are provided on the top, bottom, center, and sides 
of the bracket to aid in proper location and leveling.

1.  Locate the "left-to-right" center of the spacer and pencil 

a vertical line. Then pencil a horizontal line 7.125" down 
from the top of the spacer (see Fig. 13-2, A-B).

2.  Place the bracket over the two lines. Use the alignment 

notches in the top, bottom, center, and sides of the 
bracket to properly locate and assist in leveling (see 
Fig. 13-2, C).

3.  Using appropriate mounting hardware for the spacer 

construction; secure the bracket onto the spacer (see 
Fig. 13-2, D).

Important:  THE BRACKET MUST BE SECURED INTO 

THE SPACER STUDS TO ENSURE PROPER 
SUPPORT. A MINIMUM OF 4 SCREWS WITH 
FENDER WASHERS MUST BE EVENLY 
DISTRIBUTED AND FASTENED INTO TWO 
STUDS. ADDITIONAL SCREWS WILL BE 
REQUIRED ACROSS THE BRACKET INTO 
THE SPACER WALL, FOR COMPLETE 
SUPPORT.

To ensure a properly installed bracket, fi rst hand-
tighten all screws. Reposition the bracket as 
needed, then fully tighten.

Fig. 13-2 Install wall bracket to custom spacer

Fig. 13-1 Install wall bracket to F.M. Spacer

7.125"

mark 

center

align