Gaggenau AI230700 Installation Instruction

You can use this appliance in the air extraction or the 
recirculation mode.

Note: Ventilation may not exit through an already 
operational smoke or exhaust chimney, nor a duct 
used for ventilating furnace installation areas.

▯

If the ventilation is intended to pass through a 
smoke or exhaust that is not in operation, the 
responsible area heating inspector must give 
approval.

▯

If the ventilation passes through an external wall, 
use a telescope wall sleeve.

Note: To bind odors in circulating-air mode, you must 
install an activated carbon filter. The different options 
for operating the appliance in circulating-air mode can 
be found in the brochure. Alternatively, ask your 
dealer. The required accessories are available from 
specialist retailers, from customer service or from the 
Online Shop. The accessory numbers can be found at 
the end of the instructions for use.

Note: Turn the extractor hood on when you start 
cooking and switch it off again a few minutes after you 
have finished cooking. This is the most effective way 
to eliminate cooking vapor.

For extraction there are three ventilator speeds and an 
Intensive setting available.

Press the 

ÿ

 button to switch on the appliance.

The fan starts in setting 2.

With the buttons 1, 2, 3 or 

Ž

, set the fan speed 

according to the cooking situation.

Use the 

ÿ 

 button to switch the appliance off.

The air that is drawn in is cleaned by 
the grease filters and conveyed to the 
exterior by a pipe system.

The air that is drawn in is cleaned by the 
grease filters and an activated carbon 
filter and conveyed back into the kitchen.

#

Fan On/off

1

Fan speed 1

2

Fan speed 2

3

Fan speed 3

Ž

Intensive setting

ž

Run-on funcion

œ

Saturation display

c

Light on/off